Recent content by Dewar008

Members online

  1. D

    Shite multi

    Yeh 430 Saturday, final pass and the f**k*r starts playing games, not happy …..
  2. D

    Shite multi

    Yeh i get that, but it’s a little late when your on your last pass.
  3. D

    Shite multi

    Yeh thinking about it I did 1 hit in morn over artex with a new bag no probs Then the second hit was with the old s**t over new board and existing, that was ok until the last pass, then it turned greasy and wet, tried mediflex, plazzi and steel with no luck. And I know my timings are on point .
  4. D

    Shite multi

    I don’t see why I should have to start doing this all of a sudden do you reckon it’s a change in manufacturing
  5. D

    Shite multi

    Any you guys noticed a difference in multi lately, been using bags that go out of date mid august so no problem there. It seems to hang around for a good 3 1/2 hours then on the last pass it tears in areas, Almost like the skin is flaking off. Then usually after that long you can run your hand...
  6. D

    Mc55

    @themucky1 thanks for that, just thought the kzp may be a cheaper option to go on the keyed mc55 base as mc55 can get costly if it needs a little more straightening.....
  7. D

    Mc55

    Evening all. Anyone used baumit mc55 over painted render? Got a job to do over solid painted tyrolean, was going to mesh coat and pin, then scratch coat, when cured apply 10mm kzp 65 with sponge finish Any opinions much appreciated
  8. D

    Base coat with mesh

    Hi there I have recently been using bagged renders instead of sand and cement. Sometimes 2 passes fresh in fresh and sometimes scratch then topcoat. Occasionally using alkali mesh in the base, but always wondered why some lads leave the mesh slightly exposed in the base coat before they top it...
  9. D

    Parinter

    Evening all. I’ve got a small over render job using parex parinter but the customer wants a 1.5mm thincoat finish, I have been told you can’t use this on parinter.....has anyone successfully used a thincoat finish, if so what’s the best process?? Many thanks
  10. D

    Ewi training

    Hi there I’m after doing an ewi installation course, the trouble is I live in Cornwall! Anyone know of a decent course in the south west area??
  11. D

    Dry dash receiver

    Will be using over external wall insulation So I guess a suitable bagged base coat. Maybe try and persuade to customer on a smooth silicone or mineral finish.....
  12. D

    Dry dash receiver

    How do you guys compare a pre bagged dash receiver to a sand and cement coat. I have found s+c to pull in a little quick at times. Does the pre bagged give a longer open face time??
Top