Dansouthcoast84's latest activity
-
DYour timber frame building had a very poor spec for the rendering. I would remove all render, eml, and ply. If the condition of the ply...
-
DDansouthcoast84 replied to the thread Open car port ceiling.ocr isnt fire rated. the protection is in the board.
-
DDansouthcoast84 replied to the thread Open car port ceiling.wouldnt use gypsum cement board and render or masterboard with capped screws. Regs these days would need a fire protection so an a1...
-
DDansouthcoast84 replied to the thread Hp12 and sand and cement.HP14
-
DDansouthcoast84 replied to the thread Hp12 and sand and cement.i dont get why everyone chancing hp12 for ewi..
-
DI’m looking for a young person who’s interested in a career in plastering , based in the East Midlands at junction 25 on the m1, ideally...
-
DDansouthcoast84 replied to the thread K-rend silicone rendered to ground.Krend is not lime based. basecoat is cement, and silicone.... well its aikicone although can breathe It looks like your cottage is...
-
DHi where is the best place to order plastic render beads . thanks.
-
Din main top pic the angle the applicator gun was held at changed due to the scaffold set up. The result is like if you rub your hand...
-
DDansouthcoast84 replied to the thread Advice on render to use on timber framed house..i know a couple if you message me i will pass their details
-
DDansouthcoast84 replied to the thread Advice on render to use on timber framed house..timber frames on domestic dwellings require a cavity. usual build up. timberframe. 18mm ply/sheathingboard membrane 25mm vertical...
-
DDansouthcoast84 replied to the thread How low should base coat & top coat silicon go?.you should finish DPC height or 150mm from ground. you can put an expansion bead along dpc height to render to ground
