Recent content by cjs

I'm running a ritmo l on a maintenance free r/s ,we've been spraying hard wall this week at 325 water speed 10

What sort of dosage do you work to rigsby with the retarder? And have you tried it with k rend?

Sprayed at 3 yesterday on hp12 base coat 50sqm temps where supposed to be 12 degrees last night.got there this morning and had to hack the lot back off lol. I'm gutted really:cachetada::crying:

Yeah would of done the r7 jrend but haven't got any to hand. I'm sure someone on here has said that there r7 is just there version of sbr

If I remember rightly Clemo,there hardly anything in it for the top coat about 10-11 including vat. But the prep coat is about 16 plus vat but it has fibres in it and is also nice to spray.

Iv used there gear a few times now,but it does take a long time to go off. There prep coat is 100% waterproof so they say. I sprayed it once (top coat hbs)and the temperature was only 12 degrees ,sprayed the Wednesday and couldn't scratch it back till Friday mid day!!! But nice gear to use

I was just thinking of putting a coat of sbr over the base coat to see if this would seal it and then creat an equil suction over the whole area an hour before I spray eliminating the ghosting areas,Iv never had this problem before. By doing it an hour before I was hoping it would still give it...

Only because I'm spraying 12mm mono over the top arti

So would it be ok to put some sbr over it an hour before top coating ?

Thinking of doing a afternoon spray tomorrow,starting about 2.30-3ish k-rend on top of hp12,so it should hold it back abit. Night time temps are about 13 degrees at the mo

hi guys Anybody ever had areas of block lines ghosting through there Basecoat? Iv used hp 12 and in some areas its ghosted,and I'm a little concerned it with go through to the top coat. Iv never had this happen before and the Basecoat has been on 7 days now. Blocks where dry but it's even in...

N No mate Wales

Tripods set with a tape measure,and no slump test done an any of the trucks.

I'm not going to mention the name,as much as I want to the way I look at it now is the jobs been sorted,and lesson learned. I have to take responsibility for it myself as I should of checked the guy out before I subbed him the job.

Yes Nigel I had to scabble the whole floor,then I had to hover it within an inch of its life!! Twice I hovered it to get all the dust up in between brushing it also. I had to purchase a resin from tech floor (as gyvlon gave me a spec to work to on the preparation) So this was a two pack...