Recent content by chequers

Using parex pauramerx as a render backing coat and then two coats 1.5mm of knauff decoplus guess I could use sand cement instead of tbe parex ut the parex is sprayable

Hi yeah had considered that but the boards are too thick (12.5) which would cost in terms of then using paramerex to build up to come back over the board good idea though Can the tv 10 be pinned /mech/fixed like eml If it can how is best to do it Ta

Either sand cement render or parex pauramerx render

Before the rendered walls and plasterboard ceiling have their final coats of decoplus they will be scrimmed on the joint

With eml would you be looking at stainless or galv ? I dont know now if the pauramex would be right for this job .Will check with parex re use of pauramex with eml in case of reaction if the tv10 was bedded in with a background coat of pauramex how would this work , plan was one 15mm coat

Yes I considered that but as I was looking at parex pauramerx as the render I was thinking of using the tv10 mesh ., would this not be the same thing /performance as the eml It is easier to put the pauramex on with a spray rather than getting sand cement carried up Cheers guys for your help

The tape and joint has been finished so its nearly ready for knauff decoplus as in the above pic

They are moisture fireboards (room above) Couldnt afford alternatives ,will be spraying knauff decoplus to add moisture resistance on to ceiling What does EML mean Thanks

What about parex tv10 mesh in parex pauramex render (sandwich the mesh)? Or woild it have to be a specific mesh

Hi I cant do that , the tape on the walls are are attached to the ceiling membrane if i cut it off the membrane seal is broken , it needs to work as it is a indoor swimming pool

Hi All The walls need to be rendered but the ceiling vapour barrier is fixed to the the ceiling and comes down approx two inches ,it is like a foil tape made by visqueen I need it to be rendered ,was looking at microgobitas on to the foil and down another 4 inches or so ,render with mesh...

Hi all ok 70sqm ceiling up with siniat moisture fireboard 12.5 Had the tapered edges all filled with easyfill and sanded getting ready for plasterer to spray knauf decoplus BUT should I apply bond it or similar on such a big ceiling in a moisture filled room In my mind I think the...

Long story but got to use decoplus by knauff

Hi Got a ceiling i need finishing it is 70sqm and they are tapered edge boards . So do i get it taped and jointed and then skimmed with decoplus knauff two coats of 2mm Or is there a way of avoiding the tape and joint ,just skimming with decoplus and scrimming i dont think would work as 2mm...