Looking looking for a rough Guide ,not used it as yet I can now set the machine up no problem and strip it down for cleaning,the chap I bought it off said the setting is around 400 but I think that maybe way too much
Had two pipes the wrong way the guy who sold it me showed me the pipe work all set up so it was wrong I took photos when it was set up ,what I don’t no is the screw pump when I take it apart to clean do I have to remove the 4 bolts and take it completely apart to clean and if so who dose it come...
I have just bought a m200 machine ,I have been rendering by hand for some years all the videos on this machine looks easier then it really is. set up the m200 today for trail run and made a right pigs ear of it 1st try complete blocked strip down and cleaned ,try again 2nd time was too wet then...
I have just bought a m200 rendering machine when I connect the water pipe to the water but and turn the machine on the air go’s back in to the water but any one got a clue what I’m doing wrong
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.