After reading about it somewhere, I used gardz on some overly polished areas after plastering had been completed, and now 3 coats later it's still bloody showing through slightly! I'm using Dulux trade vinyl silk.
Does anyone know why this could be happening? Any point of a fourth coat?
Sorry if this is the wrong section.
I read somewhere that you should us 10% water for the mist coat, which I have found out is too little water. I have cut into the corners and edges of a room using this ratio. Should I go back and sand those areas back down to the plaster and start again?
Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.