Recent content by 180 wizard

sorry posting at same time .....quite like that idea deiselpower just trying to get my head round the cut angle ? so would you fix the wood above the dpc onto the dash and just use as a gide then take off after?

OK cheers , that all makes sense to me. -I'm going to take the old dash off up to dpc -then put a bellend bead on :o -then render to it leaving set back a bit from dash to form a lip for rain to come off it -*jobs a good un *!!!! hopefully i can get a nice clean edge when taking it off so i...

yeah thats just what he's after mate ! so when i take the render off at the bottom do i put the bell cast up side down up to the pabble dash ? and where on the wall is correct in relation to the DPC above /below/or on the dpc line ?

thanks guys , so how would you go about this job,its a full pebble dashed house and he only wants this drip bead or bellcast putting in a foot high and rendering flat below the dash ....,so when fitting the bellcast will i after fit it at the dash height and patch it into the pebble dash and put...

hi, A customer has just asked if i can knock all the peble dash off from round the bottom of his house to around a foot high then put some a bead along and re render flat around the bottom, he has a friend who has had it done before and says the rain water stops at the peble dash and comes off...

just had a look at these 3 (scudo/dispatch/expert) they all look very similar probably the size ill be looking for , will they all take a 6x3 boards in the back sat down and on the edge ..(might try put a rack in the back ) And in your opinions are they big enough vans for all the gear plus...

Hi , whats the bst van for the job ? i am looking to buy a van and spend around 3-4 k on it, now here is the problem i need it to have 3 seats across the front but i don't want to go as big as a transit van ! i am only bothered about getting 6x3 boards in it as i get the 8x4 's delivered...

not bad idea to join under the down spout ! think ill do that and let them slap on the tex paint ...cheers for the help guys ! :D

Think i agree with the conclusion that its textured paint, its a very thin coat ...well what would you guys do ? do you think that i could get away with rendering one coat and stippling it up or 2 very tight coats and doing my best to blend without a massive step ??? got there to do the...

https://i773.photobucket.com/albums/yy18/wizard12345/render%20pics/render2.jpg

ive got one more pic ill just go post it! woodchip ha ha ;D

https://i773.photobucket.com/albums/yy18/wizard12345/render%20pics/render1.jpg see if that works!! would you use any sharp sand in the mix ? to get the gritty texture?

hi , been plastering for a long while now but not done a massive amount of rendering ,just the odd garage and gable ends ..always 2 coated with sand and cement and finished the render to a smooth finish with the sponge ...my problem at the moment is i have a small extension to do for this...

SO I TAKE IT THATS THE BIT HOLDER ON EBAY AND YOU NEED TO PUT A PHILIPS BIT IN THE END ? MINE IS A ONE PIECE BIT , I WENT TO SCREWFIX THE OTHER DAY AND THEY SELL ALL THE SENCO GUNS BUT DONT SELL THE SPARES TO GO WITH THEM !! NOT RIGHT GOOD ! DO YOU NO ANY OTHER HIGH STREET SHOP WHAT MIGHT SELL...

HI GUYS , CAN ANYONE TELL ME WHERE I CAN GET HOLD OF A NEW DRIVER BIT FOR MY SENCO DS202 ?