stonesy
New Member
Hi, I've recently had a render job done with PRB TCR - and after 2 months I've got loads of crazing and weird yellowing/red staining on the surface.
It was applied with basecoat, mesh, primer and then top coat, 10mm beads on dense block
Anyone got any ideas why it's ended up looking like this?
It was applied with basecoat, mesh, primer and then top coat, 10mm beads on dense block
Anyone got any ideas why it's ended up looking like this?
Attachments
-
121215568_377397566952188_2019562223673461309_n.jpg551.6 KB · Views: 229
-
121260759_361803688200899_4145433159801857323_n.jpg650.4 KB · Views: 234
-
121232592_379670803420027_5935979407266189121_n.jpg544.4 KB · Views: 233
-
121289685_2651913911787360_1422930924313008722_n.jpg470.6 KB · Views: 242
-
121259229_1218988985153788_21222171864348300_n.jpg393.1 KB · Views: 228
-
121261418_2449141655387729_1878676583952882860_n.jpg495.7 KB · Views: 214
-
121145095_355878862399110_2883431609622088747_n.jpg493.7 KB · Views: 229
-
121235688_404363490554777_9055425713602132306_n.jpg463.1 KB · Views: 203
-
121147467_358594692244593_2300297495693354689_n.jpg488 KB · Views: 209
-
121232592_379670803420027_5935979407266189121_n.jpg544.4 KB · Views: 209
Last edited: