half time accelerator v speedy set accelerator

anyone tested both these against each other,read speedy has fibres in it which i dont fancy in my finish.
i want to try some.
Both were similar on time I seen the speedy one dried out too on a job and looked good uniform colour mate
Both I liked as they pull in just right in colder weather if doing smaller one bag hits
 
Both were similar on time I seen the speedy one dried out too on a job and looked good uniform colour mate
Both I liked as they pull in just right in colder weather if doing smaller one bag hits
Were fibres visible in speedy vince.
 
Were fibres visible in speedy vince.
Tbh mate I only had about 8 sachets and just put them straight in , could only find these two pictures from that time
B1DAC810-5891-4291-837D-B0E94DA19DE4.jpeg
F6F11AFC-15B0-4F9B-A699-0588623C5613.jpeg
 
Does anyone keep any on there van just out of interest?
I order a 20 pack to have on there through winter when on internal work, I don’t use them all the time but when needed they are a god send
 
Does anyone keep any on there van just out of interest?
I order a 20 pack to have on there through winter when on internal work, I don’t use them all the time but when needed they are a god send
I have them in the van, box of 50 £90. Like you say in winter when there a lot of moisture in the air and boards are damp they are good. Throw one sachet in to 3 bags, then another in second coat 1.5 bags. Stops it acting the goat.
 
Were fibres visible in speedy vince.
No Fibres cant be visable, even on blends , we have the fibres specially machined for the purpose (and are very expensive) , but they give you up to 30% stronger set plaster. If mixed as per instructions ( ie in clean water clean bucker and whisked for a few seconds , there will never be an issue . Some accelerators weaken the plaster , ours strengthens the plaster . We also add a stabaliser so it makes the plaster creamier, and stops the finish plaster being greasy ( even in half doses ).
 
So you wont be bringing out seperate ones of your own in the future?
Hi, No we wont , as we have it all covered with the 2 we sell , there is no need to . Our products work on all gypsum based products . Our Speedyset sets it quicker ( per instruction 1 hr quicker , but add more itll set quicker , down to 15 mins if you so choose ) and our Slowset makes it sets slower. We are a full time plastering company running 2 teams . We use the best chemicals for our products and not cheap crystalised chemicals that can weaken your end product . We add a stabalizer into both additives to help " Spreadability ) and also our unique fibres that give a considerable advantage on strength. Weve been selling to teams for over 3 years now , but we are only a small company. We sell on ebay.
 
Top