Jackbracks
Member
Hello.
Thanks for having me.
First time posting on here... iv done a few small monocouche jobs using weberpralM the last couple of years and all seemed to go well enough . Agreed to do hack off and re-render a small bay window area for a customer only to discover it was hollow (straight onto mesh and timber battons)
I wouldn’t even know where to start on what system to use to render it properly to be honest.
Called weber technical, they’ve sent me over an email recommending and detailing the ‘MT118P’ system.
All seemed a bit confusing...
Can anybody talk me through some experiences of what is the most simple/effective and ideally cost effective system to use? If I have to go ahead and order all the gear in for what weber are suggesting then fair enough... just had zero experience in doing one before that’s all so any advice be much appreciated .
Thank in advance
Jb
Thanks for having me.
First time posting on here... iv done a few small monocouche jobs using weberpralM the last couple of years and all seemed to go well enough . Agreed to do hack off and re-render a small bay window area for a customer only to discover it was hollow (straight onto mesh and timber battons)
I wouldn’t even know where to start on what system to use to render it properly to be honest.
Called weber technical, they’ve sent me over an email recommending and detailing the ‘MT118P’ system.
All seemed a bit confusing...
Can anybody talk me through some experiences of what is the most simple/effective and ideally cost effective system to use? If I have to go ahead and order all the gear in for what weber are suggesting then fair enough... just had zero experience in doing one before that’s all so any advice be much appreciated .
Thank in advance
Jb