hi.we have a Mtec m330 and just replaced rotor and stator.we put the new one in and it was coming out way too fast then got really hot and was smelling like burning rubber!the motor and mixing paddle wasn't hot.we had to put the old one on mid panel and not over heating just quite slow coming out!anyone had similar problems or could it b any other replaceable part?only had it serviced 3months ago!cheers
Machine problems
- Thread starter Rst1983
- Start date
user__removed
Private Member
Did you put it together the right way round? If that's even possible
Arti
Well-Known Member
Weberwizard
Member
Maybe your generator is to powerful I wouldn't use anything bigger than a 15 kva
Wat happened to ur low output pump. Was it similar symptoms or just a user error
user__removed
Private Member
User error, water was too low.
Ooossshh you beehatch
same rotor and stator and consistency was nice but coming out the gun way to quick n then it was stinking of burning rubber and then stopped even working!only done about 3000m2 of machine applied mono render so still green when it comes to understanding the machine,why wud it come out so fast and get so hot tho the motor n paddle was fine?thanx
User___removed
Well-Known Member
Where the winkle picker when you need him!!!
Plasterers1StopShop
Well-Known Member
Sorry for the late reply.
Which rotor and stator are you using? The Unistar has a output of 24l/min which will appear quick at first
Who are you? I will call you tomorrow to discuss what it could be
Which rotor and stator are you using? The Unistar has a output of 24l/min which will appear quick at first
Who are you? I will call you tomorrow to discuss what it could be
Last edited:
Did you lubricate the grommet on the isolation switch before you set the water?