Ok not many used this then!!
I used k-rend Gp today and it rubs up really nice but had problems with it picking up in pipes ?
I was using G4 spraying at around 300 with d63 . I primed machine then ran material through machine until right consistency, then added pipes sprayed for around 5 minutes and was fine but then just went really wet and then noticed it had bridged. rotor and stator has only done 2 pallets.
Any ideas would be welcomed as i dont get this problem normally with k1 or weber?
Scratch coat leave to dry out.
When you come back to top it treat as normal site mix as that's why it is.
Wet the scratch down, quick cup of tea then lay it on. It will finish and float same as
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.