If I was a Mr know it all I wouldn't have stuck plasterboard on a solid wall and asking you guys the best way to sort it. Like I said your just one of them guys who likes to spout off because you have nothing better to do and it makes you feel better I'm gonna leave it there with you because you...
Dunno what your on about but maybe you should learn to read previous posts lol. I deserve everything I get I have done this project as a learning curve so I have expected to make mistakes. I have not moaned about it. I except I should have got more advise than off one person who I thought he...
No I put a damp course in under the concrete floor which went over the top of the blocks so the floor inside and damp course is above ground level. As for the block they was standard 100mm solid 7.3nm. I think it's all to do with cold spots or hasn't fully dried out either way what flynnyman...
I hope that's a good thing doing as you say I don't wanna be doing it a 3rd time To be fair iv read lots of other posts which say similar stuff just some talk about vapour barriers. Lucky for me the other half the building (the shed half) hasn't been boarded on the exterior wall so before...
I am thinking of doing what flynnyman says. But doing a little bit more thinking is there any thing I can do on the exterior wall which is sand and cement render at the moment maybe insulation on the out side would this cost more tho.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.