So I set up the machine using the pump andy loaned me. But didn't attach to. Machine just let the water run through the pump into the hose and back into the butt. No problems ran fine for ten min ample pressure and volume. Then I attached it to the machine and the pump cut out as the pressure built up as it shud. I removed the the pipe from the inlet to the mixing zone and pressed the water switch on the caddy and it kicked back up and filled three buckets without the float dropping at all. I then attached the pipe back to the mixing zone and remove the cap from the the out let to set the level . I pressed the water switch again and let it run for a while and the float stayed put again. I let the water settle and the replaced the cap once the level was set. Then I pressed the switched for the motor it started up the water in the mixing zone passed through the r& s but then shut off as it didn't kicked up the pump. So I tried it by attaching the airline turning on the comp and then opening the valve on the airline still nothing. Wtf am I just being stupid here sum where I'm doin everything as I did b4 and was spraying no probs.