Pj
- Thread starter Ppj
- Start date
spunky
Private Member
If you did try bending it a bell cast would maybe look better with the bead arris
Tbh I’ve never done one if it’s a small window I’d imagine the only way would be a timber former and free hand the next pass or an angle bead with loads of cuts in it but they can still look like a 50p piece
Tbh I’ve never done one if it’s a small window I’d imagine the only way would be a timber former and free hand the next pass or an angle bead with loads of cuts in it but they can still look like a 50p piece
000
Well-Known Member
Ridiculous ——————————————————————-
Wakey wakey
Salfordspread
Active Member
spunky
Private Member
Do they make them malc at a render thickness I’ve only seen them for skimming
Salfordspread
Active Member
Neither have I
000
Well-Known Member
essexandy
The Lake Governor
Yes they do mate, I've used them a good few times.
ChrispyUK
Well-Known Member
No you haven’t
Salfordspread
Active Member
000
Well-Known Member
000
Well-Known Member
Not a Float bead !!! ——pay attention ____________________
Wakey wakey
themucky1
Well-Known Member
That’s only 6mm pal, assuming when they say k-rend they mean mono minimum thickness should be approximately 12mm
essexandy
The Lake Governor
I was replying to Damien about a arch render bead, they work just fine with sand and cement.
We've had them in the past with a 10mm arris as well and used those with Parex Monoblanco.
Salfordspread
Active Member
Exactly he's on about mono not thin coat the plot thickens
Salfordspread
Active Member
That's only 6mm that's why ply is a better option unless there's a thicker one out there fik knows